106 STAT. 2822 PUBLIC LAW 102-486—OCT. 24, 1992 "(B) If the test procedure requirements of ASME Al 12.19.6- 1990 are revised at any time and approved by ANSI, the Secretary shall amend the test procedures established by subparagraph (A) to conform to such revised ASME/ANSI requirements unless the Secretary determines, by rule, that to do so would not meet the requirements of paragraph (3).**; (2) in paragraphs (1) and (2) of subsection (c), by inserting "or, in the case of showerheads, faucets, water closets, and urinals, water use" after "efficiency^ each place it appears; (3) in subsection (c)(2), in the material preceding subparagraph (A), by inserting "or established" after "prescribed"; and (4) in subsection (e)— (A) in paragraph (1), by striking out "or measured energy use" and inserting in lieu thereof", measured energy use, or measured water use"; (B) in paragraph (2), by striking out "energy efficiency or energy use" each place it appears and inserting in lieu thereof "energy efficiency, energy use, or water use"; and (C) in paragraph (3), by striking out "energy efficiency or energy use" and inserting in lieu thereof "energy efficiency, energy use, or water use". (e) LABELING.—Section 324 of such Act (42 U.S.C. 6294) is amended— (1) in subsection (a)(2), by adding at the end the following new subparagraphs: Regulations. "(C)(i) Not later than 18 months after the date of the enactment of the Energy Policy Act of 1992, the Commission shall prescribe labeling rules under this section applicable to general service fluorescent lam^s, medium base coinpact fluorescent lamps, and general service incandescent lamps. Except as provided in clause (ii), such rules shall provide that the labeling of any general service fluorescent lamp, medium base compact fluorescent lamp, and general service incandescent lamp manufactured after the 12-month period beginning on the date of the publication of such rule shall indicate conspicuously on the packaging of the lamp, in a manner prescribed by the Commission under subsection (b), such information as the Commission deems necessary to enable consumers to select the most energy efficient lamps which meet their requirements. Labeling information for incandescent lamps shall be based on performance when operated at 120 volts input, regardless of the rated lamp voltage. "(ii) If the Secretary determines that compliance with the standards specified in section 325(j) for any lamp will result in the discontinuance of the manufacture of such lamp, the Commission may exempt such lamp from the labeling rules prescribed under clause (i). Regulations. "(D)(i) Not later than one year after the date of the enactment of the Energy Policy Act of 1992, the Commission shall prescribe labeling rules under this section for showerheads and faucets to which standards are applicable under subsection (j) of section 325. Such rules shall provide that the labeling of any showerhead or faucet manufactured after the 12-month period beginning on the date of the publication of such rule shall be consistent with the marking and labeling requirements of ASME A112.18.1M-1989, except that each showerhead and flow restricting or controlling spout-end device shall bear a permanent legible marking indicating the flow rate, expressed in gallons per minute (gpm) or gallons
�
