Page:United States Statutes at Large Volume 124.djvu/4157

124 STAT. 4131 PUBLIC LAW 111–380—JAN. 4, 2011 Public Law 111–380 111th Congress An Act To amend the Safe Drinking Water Act to reduce lead in drinking water. Be it enacted by the Senate and House of Representatives of the United States of America in Congress assembled, SECTION 1. SHORT TITLE. This Act may be cited as the ‘‘Reduction of Lead in Drinking Water Act’’. SEC. 2. REDUCING LEAD IN DRINKING WATER. (a) IN GENERAL.—Section 1417 of the Safe Drinking Water Act (42 U.S.C. 300g–6) is amended— (1) by adding at the end of subsection (a) the following: ‘‘(4) EXEMPTIONS.—The prohibitions in paragraphs (1) and (3) shall not apply to— ‘‘(A) pipes, pipe fittings, plumbing fittings, or fixtures, including backflow preventers, that are used exclusively for nonpotable services such as manufacturing, industrial processing, irrigation, outdoor watering, or any other uses where the water is not anticipated to be used for human consumption; or ‘‘(B) toilets, bidets, urinals, fill valves, flushometer valves, tub fillers, shower valves, service saddles, or water distribution main gate valves that are 2 inches in diameter or larger.’’; and (2) by amending subsection (d) to read as follows: ‘‘(d) DEFINITION OF LEAD FREE.— ‘‘(1) IN GENERAL.—For the purposes of this section, the term ‘lead free’ means— ‘‘(A) not containing more than 0.2 percent lead when used with respect to solder and flux; and ‘‘(B) not more than a weighted average of 0.25 percent lead when used with respect to the wetted surfaces of pipes, pipe fittings, plumbing fittings, and fixtures. ‘‘(2) CALCULATION.—The weighted average lead content of a pipe, pipe fitting, plumbing fitting, or fixture shall be cal- culated by using the following formula: For each wetted compo- nent, the percentage of lead in the component shall be multi- plied by the ratio of the wetted surface area of that component to the total wetted surface area of the entire product to arrive at the weighted percentage of lead of the component. The weighted percentage of lead of each wetted component shall be added together, and the sum of these weighted percentages shall constitute the weighted average lead content of the product. The lead content of the material used to produce 42 USC 1201 note. Reduction of Lead in Drinking Water Act. Jan. 4, 2011 [S. 3874]