houses, one above the steps and the other below. The lower house on the eastern side of the stream is a mere heap of ruins with, however, the door-jamb standing and facing the north.[1] No wheel-pit is visible, but there are traces of a watercourse at a high level to the north-east of the hut. Near the entrance is a stone with one perfect mould in it, and another imperfect. A second mould-stone is lying near an angle in the eastern wall of the house. It has in it two moulds adjoining each other—one at a lower level than the other, and connected by a channel. The high-level cavity is 15 inches long, 8 inches wide, and 3 inches deep. At one end is a groove one inch deep, perpendicular, and running down the side of the mould three inches; that is, from top to bottom.
The low-level mould is 17 inches long, 12 inches wide, and 5 inches deep. These cavities have been used for the purification of tin, for the molten metal mixed with furnace impurities poured in on the high-level hollow would flow in a purer condition into the low-level mould.
This blowing-house has been excavated, somewhat superficially, but nothing was found in it to give token of the period to which it belonged. About a quarter of a mile further up the river, but on the western bank, is another ruin. The doorway, which is very imperfect, is on the eastern side. One mould-stone remains, containing a mould 17 inches long, 12 inches wide, and from 4 to 5 inches deep.
- ↑ This is the scene chosen by me for my story Gitavas the Tinner.
