user's issuing a single quit signal (varying with the console type) which may be issued even if the console is typing out. Upon issuance of the quit signal, the user's console input level is raised by one, normally back to level 0.
In addition to this basic two-level scheme, it is possible for the user to extend the number of input levels, thereby allowing for program subsystems, each with its own control language (e.g., for debugging). This is accomplished by the program giving subroutine calls to the supervisor, which on each entry drops the user console a level (to a limit of level 3). Whenever a quit signal from the console is received by the supervisor, the user's input level is raised by 1 (but no further than level 0); control is returned (by means of a push-down list) to the subsystem entry point previously assigned by the program to the current level, or finally, after the right number of quit signals, to dormant status.
Character Mode Switch
For routine computer work, especially older applications, the normal 7090/94 BCD character set is sufficient for console messages. This set consists of 47 characters and blank, augmented by a few console control functions, namely: carriage return, tabulation, back space, color shift, delete-last-character, delete-last-message, and ignore; this normal BCD set is contained in a 6-bit code. When the character mode switch of a console is set to "normal", a console will transmit in the normal BCD mode.
The user's program, however, by issuing specific subroutine calls to supervisor entry points, may change the character switch to the "full" setting which, by means of a 12-bit character code, allows the user precise knowledge of console input as well as full flexibility upon output. Whenever a user program is completed and the supervisor is receiving input from a console at the command language level, the character mode switch is automatically restored to the "normal" setting.
Consoles and Character Sets
Each type of console attached to CTSS has associated input-output
17
