representations of all these minor varieties, as even more than enough are engraved to show the general character of the instruments. It is perhaps worth mentioning, that the flakes selected for conversion into scrapers are usually such as expand in width at the point. It is doubtful whether the long narrow flakes worked to a scraper-like termination at one or both ends properly come under the category of scrapers. I shall consequently treat of them under the head of wrought flakes.
|
| |
| Fig. 218.—Bridlington. | Fig. 219.—Bridlington. |
I must now pass on to the consideration of the forms showing a greater extent of trimming at the edge than those hitherto described. Of these the double-ended scrapers, or those presenting a semicircular edge at either end, first demand notice. They are of by no means common occurrence. Those I have seen have been for the most part found in Yorkshire and Suffolk. Fig. 218 exhibits a specimen from. Bridlington. As is not unfrequently the case, it is rather thinner at the end nearest to what was the butt-end of the flake. The sides are left almost untrimmed, but each end is worked to a nearly semicircular curve. In the Greenwell Collection is a specimen from one of the barrows at Rudstone; as well as a large one from Lakenheath, and others from Suffolk. Occasionally the length and breadth are so nearly the same, that the scraper assumes the form of a disc, with sharp edges—a kind of plano-convex lens. A specimen of this form from Bridlington is shown in Fig. 219. It is, however, exceptionally regular in form. I have another smaller specimen, not quite so circular or so well chipped, which I found on the Downs between Newhaven and Brighton, and I have others from Suffolk. Such a form was probably not intended for insertion in a haft.
Fig. 220.—Yorkshire Wolds.
Sometimes, where the scraper has been made from a flat flake, the trimmed edge curves slightly inwards at one part, so as to produce a sort of ear-shaped form. I have such, both with the inward curve on the left side, as shown in Fig. 220, and also with it on the right side.
A deeply-notched tool, to which the name of hollow scraper has been applied, will be subsequently mentioned.[1]
- ↑ P. 319.
