Fig. 236.—Bridlington. 12
Another much coarser but somewhat similar form is shown in Fig. 236. The instrument in this case is made from a very thick curved flake, roughly chipped into a boat-like form, and then more carefully trimmed along the edges. It may possibly have been used as a borer, as the edges near the point show some signs of attrition. It is of flint weathered grey, and was found near Bridlington. I have found a similar scaphoid form in Ireland.[1]
A rather thick external flake, worked over nearly the whole of its convex face and reduced to about half its breadth for about a third of its length from the point, is shown in Fig. 237. The narrower part is nearly semicircular in section. It is difficult to imagine a purpose for this reduction in width; and it hardly seems due to wear. I have, however, another specimen, also from the Yorkshire Wolds, reduced in the same manner along fully three-quarters of its length.
Some of the worked flakes from the Dordogne Caves[2] show a somewhat similar shoulder, but it seems possible that with them the broader part may have been protected by some sort of handle, as the original edge of the flake is there preserved.
|
|
| ||
| Fig. 237. 12 Yorkshire. |
Fig. 238. 12 Bridlington. |
Fig. 239. 12 Castle Carrock. |
I now come to the instruments with more acute edges, made by dressing the convex face of flint flakes. Of these the form shown in Fig. 238 is allied to that of Fig. 235, but is considerably flatter in section and more distinctly oval in outline. The original was found near Bridlington. A hard particle of the flint has interfered with the regular convexity of the worked face, but in some specimens the form is almost as regular as a slice taken lengthways off a lemon, though in others the outline presents an irregular curve. The flat face is generally more or less curved longitudinally, and the ends are sometimes more pointed than in the specimen engraved. I have an exquisitely chipped and perfectly symmetrical implement of this character (3 inches) from the neighbourhood of Icklingham, Suffolk, in which county the type is not uncommon. The flaking on the convex surface is very even and regular, and produces a slightly corrugated surface, with the low ridges following each other like ripple marks on sand. The edge is minutely and evenly chipped, and is very sharp. The instrument may perhaps be regarded as a sort of knife.
The form is well known in Ireland, but I do not remember to have seen it in foreign collections.
The beautifully wrought blade of flint, shown in Fig. 239, presents
