it over the lines or letters, the dust will fall through in a fine shower. The powder should fall only on the part to be gilt. Cut the gold into strips, take it up upon the tool, and work rather hot. The overplus of the powder can be brushed away when the finishing is completed. Finishing powder is now sold commercially.
Velvet is very seldom finished beyond having the title put on, and this should be worked in blind first and with moderately large letters, or the pile will hide them.
Silk is finished more easily, and can, if care be taken, have rather elaborate work put upon it. In such a case, the lines or tools, which must be blinded-in first, may be glaired. For this purpose the glaire must be put in a saucer or plate in the free air for a day or two, so that a certain amount of water or moisture of the glaire may be evaporated; but it must not be too stiff so as to prevent the brush going freely over the stuff. Great care, however, must be taken, or the glaire will spread and cause a stain. A thin coat of paste-water will give silk a body and keep the glaire from spreading to a certain extent, but I think the best medium for silk is the dry one, and it is always ready for instant use. In using glaire the gold is laid on the silk, but on no account must any oil or lard be rubbed on it for the temporary holding of the gold. Rub the parts intended for the gold with the finger (passed through the hair), or with a clean rag lightly oiled, and when the tools are re-impressed a clean piece of flannel should be used to wipe off the superfluous gold.
Blocking has been used lately on silk with some success in Germany. The blocking plate is taken out of the press, and the gold is laid on it, and then replaced in the press. The finishing powder is freely distributed over the silk side, which is laid on the bed of the press. On pulling the lever over, the block descends and imprints the design in gold on the silk. This process may be applied to velvet,
